Star Properties

• Corners/Tips: Set the number of corners on the inner circle of the star (equals the number of tips on the outer circle of the Star). Default: 5, Min: 3, Max: 300.

• Star Radius: Set the radius of the outer circle (where the tips of the star are located). Default: 50, Min: 1, Max: 200.

• Star Inner Radius Factor: Factor of the outer radius to the inner radius of the star. A value of 1.0 means that the inner radius of the star is identical to the Star Radius value. Default: 2, Min: 0.25, Max: 50.

• Hole: Place a hole in the Star geometry. Default: 0 (Off).

• Hole Radius: The radius of the outer circle where the tips of the hole are located. Default: 25, Min: 1, Max: 200.

• Hole Inner Radius Factor: Ratio of the outer radius to the inner radius of the hole. A value of 1.0 means that the inner radius of the hole is identical to the Hole Radius. Default: 2, Min: 1, Max: 50.

To Create a Star

1. Create a new container.

2. Add the Star plug-in to it (1 (default Star)).

3. Open the Star editor.

4. Modify the Star parameters, for example (2).

   • Corners: 10

   • Star Radius: 60

   • Star Inner Radius Factor: 6.0

   • Hole: On

   • Hole radius: 50

   • Hole Inner Radius Factor: 9.0

5. If required, add a material and/or a texture.