Documentation Center

Viz Artist User Guide

Version 3.12 | Published October 17, 2019 ©

Cube

images/download/attachments/41798020/viz_icons_cube.png
Use this plug-in to create cubes with particular widths, heights, depths and other attributes.

Note: This plug-in is located in: Built Ins -> Geom plug-ins -> Default

This page contains the following topics and procedures:

Cube Properties

images/download/attachments/41798020/plugins_geometries_bipcubeedit.png

  • Use LOD: Enables/disables dynamic level of detail.

  • Size X: Sets the size of the cube in the X-axis. Parameter name: size_X.

  • Size Y: Sets the size of the cube in the Y-axis. Parameter name: size_Y.

  • Size Z: Sets the size of the cube in the Z-axis. Parameter name: size_Z.

  • Center Y: Sets the position of the cube center along the Y-axis. You can choose between Center, Bottom or Top. Parameter name: center_Y.

  • Tesselation: Sets the degree of detail. Parameter name: tesselation.

  • Adaptive Tesselation: Adjusts tesselation on each axis separately, depending on the extension of the cube on that axis. The reference value is an extension of 100. For a face of size 200, the tesselation-parameter is doubled, for a face of size 50, the tesselation is halved. The automatically adapted tesselation still never exceeds its maximum value of 100. Parameter name: adaptiveTesselation.

  • Bevel: Adds a bevel of the given size to corners and edges of the cube. The size of the bevel reduces the size of the cube’s axis-aligned faces which: in the case ‘Adaptive tesselation’ is enabled causes them to become less tesselated accordingly. Tesselation of the bevel itself is affected by ‘adaptive tesselation’ too. Parameter name: bevel.

  • Rounded Bevel: Rounds the beveled edges and corners when set to On. The roundness of the bevel is tesselated is affected by adaptive tesselation. Parameter name: roundedBevel.

  • Show Top, Bottom, Front, Back, Left, Right: Shows or hides the cube’s face and adjacent corners and edges. Parameter names: Top, Bottom, Front, Back, Left and Right.

  • Show Size 0: Enables/disables display of the cube at axis value zero (0). If one of the axis values are set to 0, the cube remains visible if the setting is enabled (On). Disabling (Off) it makes the cube become invisible as long as one of the axis values are 0. A situation where this parameter is useful is when creating bar chart animations. In such animations it is possible to hide the bar at value 0 by disabling this setting.

To Create a Cube

images/download/attachments/41798020/plugins_geometries_bipcube_example.png

  1. Create a new group container and add the Cube plug-in to it.

  2. Add a material and/or an image to the same container.

  3. Open the cube editor and set Rotation Y and Z values to 45.0.